 |
||||||||||||
|
Radio
Broadcast Technical Consulting and Sales
|
|||||||||||
|
Gentner
VRC Metering Sample |
||||||||||||
|
Built by M. W. Persons and Associates, Inc. |
||||||||||||
This is a 16 channel metering sample adjust panel for use with a Gentner VRC-1000/2000 Dial-Up Remote Control System. The panel has 10 turn trim-pots and capacitors to smooth out metering samples before they go to the remote control. The capacitors are non-polarized so that positive and negative metering samples can be accommodated. The panel allows adjustment of the metering, as read by the remote control, to be adjusted quickly without the requirement to adjust the software metering constant. This can save considerable time for the operator or engineer.
A back view shows the trim-pots and 3 foot cables. This unit is designed to interrupt an existing metering input to a remote control. The connector that would have plugged into the remote control instead plugs into a 37 pin D connector which has female threaded standoffs. These standoffs allow the mating connector to attach tightly without a chance of accidentally falling off. That connector is shown on the right. The output connector is on the left. It plugs into the Gentner remote control as the original connector would have.
The adjustment panel is 1.75" high and 19" high for standard rack mounting. The panel has rolled top and bottom edges so the panel does not flex backward when adjustments are being made from the front. The panels are $295.00 each plus shipping and tax were applicable.
If a terminal strip is desired for the metering inputs, the panel is 3.5" high and 19" wide. See below:
The cost of the units with screw terminal strips is $325.00 each plus shipping and tax where applicable.
|
Questions?
|
page last edited 05/11/2008
