| Home |
| New Equipment |
| Used Equipment |
| Specials |
| Our Office |
| What We Do |
| Customers |
| Rate Card |
| Web Links |
| Personal |
| Contact Us |
Radio
Broadcast Technical Consulting and Sales
10032 Island Drive, Brainerd, MN
56401
|
|
|||||||||||||
|
Radio
Broadcast Technical Consulting and Sales |
||||||||||||
|
|
|
||||||||||||
|
Automatic Restart |
|
|
| We have built a number of these for clients. This Automatic Transmitter Restart circuit does just that. It restarts a transmitter after a power blip or power outage. Lights indicate incoming power, when the restart circuit is active, and when the restart relay is being closed. The switch will allow the end-user to enable or disable the restart function. |
|
|
| Rear panel shows the connections and layout are shown here. Normally open relay contacts close to turn filaments on and plate on simultaneously. The 45 second sequence is one second on, six seconds off, then one second on again etc. |
| These units are one rack unit (1-7/8 inches) high and 19 inches wide. They run on 120 VAC power and sell for for $350 each. They are built on demand so it could take a week before we can build and ship one. |
|
Back to the Custom Equipment
Page Questions?
|
Return to Home Page
|
page last edited 10/04/2009
